Address Resolution Protocol (ARP) is a telecommunications protocol used for resolution of network layer addresses into link layer addresses, a critical function in multiple-access networks. ARP was defined by RFC 826 in 1982. It is Internet Standard STD 37. It is also the name of the program for manipulating these addresses in most operating systems.
ARP is used to convert an IP address to a physical address such as an Ethernet address.
ARP usually is implemented in the device drivers of network operating systems. It is most commonly seen on Ethernet networks, but ARP has also been implemented for ATM, Token Ring, and other physical networks. RFC 826 documented the initial design and implementation of ARP.
ARP works on Ethernet networks as follows. Ethernet network adapters are produced with a physical address embedded in the hardware called the Media Access Control (MAC) address. Manufacturers take care to ensure these 6-byte (48-bit) addresses are unique, and Ethernet relies on these unique identifiers for message delivery. When any device wishes to send data to another target device over Ethernet, it must first determine the MAC address of that target given its IP address These IP-to-MAC address mappings are derived from an ARP cache maintained on each device. If the given IP address does not appear in a device's cache, that device cannot direct messages to that target until it obtains a new mapping. To do this, the initiating device first sends an ARP request broadcast message on the local subnet. The host with the given IP address sends an ARP reply in response to the broadcat, allowing the initiating device to update its cache and proceed to deliver messages directly to the target.
No comments:
Post a Comment